6/23/12 Richland and Rome twp fire dept derby OH

[miller11]

June 23 2012
Athens Co Fairgrounds, Athens Ohio
Registration starts at 4pm
Classes Payout
Lawn Mowers 50% take in
Welded V8 $1000 gaurenteed to win
Welded Compact $1000 gaurenteed to win
Stock V8 $800 gaurenteed to win
Stock Compact $800 gaurenteed to win
Grocery Carts 50% take in
Grocery carts will be provided

Contact Dale Sinclair at [phone]

More info and rules to come!

[DerbyMaMa]

this thread has been linked to the 2012 OH state schedule thread

[miller11]

RULES
Out Law Mowers
1.You may run front and rear bumpers
2.Must have leg protectors
3.No protecting tires. They must be open!
4.Please shorten exhaust pipes for safetey reasons!
5.Everything else is fair game!
6.Please make your mower safe!

Compact Stock
1.There will be no welding on cars except driver's side door, rear end gears and motor mounts
2.You may run inside door bars, one down each side, one in front above steering column, and one behind the seat within 6 inches of the seat
3.You may run gas tank protector, must be no wider than 24", must not go beyond rear hump
4.No tractor tires allowed, must be D.O.T. tires only
5.All cars must have drivers seatbelt
6.Must have stock suspension. NO EXEPTIONS!
7.Hood and trunk may be wired in six places. It must be wired to body ONLY!
8.Doors may be wired or bolted shut
9.Must wear D.O.T. approved helmet
10.No wedging of the back of the car
11.All cars will be drilled in frame rails,two holes, front and back. NO EXEPTIONS!
12.Maximum whellbase is 109" but must be a unibody car ONLY!
13.Two strands of wire per hole, 12 gauge wire only
14.You may run header pipe! Otherwise cut exhaust off at the bottom end of the downpipe.
15.Car height must be 22" maximum and 16" minimum

Compact Welded
1.2011 Smash It Rules
2.You may plate rear humps on the coil spring cars 22" maximum only
3.You may run any type tire
4.You may run two kickers down to the frame on your bar behind the seat
5. Gas tank protectors must be no wider than 24", no farther back than the inside rear hump. 11" hump plates on leaf spring cars
6.Bumper can be reinforced in the inside
7.You may run all thread for shocks, maximum height 22 inches front and rear to bottom if the bumper. You may weld "A" frames on front
8.Tires may be doubled or loaded!
9.Coil car must stay coil
10.You may use 1" maximum all thread
11.You may run angle iron on top of radiator support
12.If you patch frame rail you must have a picture of te spot
13.Car height must be 22" maximum and 16" minimum
14.You may plate sway bar on the ouutside four inches maximum
15.ou may run kicker to front bar to behind strut tower on a frame
16.If you run a car with sunroof make sure you run a support to max, two inches square in the middle or drivers side for strength above your head in the sun roof hole
17.If pre ran car you may plate kink up to six inches
18.107" wheel base, must be uni body car only
19.You may weld two kickers down to center hump behind seat on rear bar

Stock V-8 Cars
1. Same rules apply as compact stock
2.Maximum bumper height is 24" to the bottom of the bumper, 16" minimum to the bottom of the bumper

Welded V-8 Cars
1.2011 Smash It Rules apply
2.You may run tow kickers in the front from radiator support to the frame, must not extend any further than 16" from the radiator support
3.You may run any type of tire
4.You may weld or run all thread to hold the suspension on front, just all thread on rear for car height, 1" all thread maximum
5.You may run leaf springs or coil springs on rear, no more than 9 leafs per side
6.You can hump plate frame rails on coil car up to 22" maximum, 11" from center of wheel well each way or 11" on leaf car
7.You may run kickers inside of car from the frame on floor to back seat bar
8.Gas tank protectors must be no wider than 24", no farther back than inside of rear hump
9.You may run transmission coolers inside of car but must be fastend shut
10.If pre ran car you may plate fron if kinked if it has been bent up to 6"
11.You may cap where coil springs sets no wider than 8" on lower A frame
12.No loading or plating the rest of the frame anywhere, we will be checking
13. No doubleing panels, all doors must have top open
14.If car is wedged it must have 6" between floor and trunk lid
15.If station wagons are ran the back door must have top open to see in
16.Door bar may have corner gussets
17. Please paint numbers where we can read them or run a 12" by 12" roof sign
18.Maximum height 24" to the bottom if the bomper, 16" minimum

For more info or questions call Dale Sinclair [phone]

[39x]

is anyone running here?

[booie1127]

i will be!

[smash]

good luck to all drivers run this show